Cheesemaking.co.za/shop NEW FAQ :-)

https://cheesemaking.co.za/shop/faq

Looking for a good cheese making FAQ (frequently asked questions page)? Check out our new Frequently Asked Question page on Cheesemaking.co.za/shop!

We will add to it regularly, with own content and answering submitted questions.

Here is just one example question we answer and we will update as needed:

What to do if milk doesn’t become curd/Why is the milk not coagulating/Curds not forming/Curd not setting

When it comes to cheese making trouble shooting this is probably the question we get the most.   The question usually arises with rennet set cheeses, but milk can set/coagulate in 3 ways during normal cheesemaking: 

1. Acid set (Yoghurt, kefir, paneer, amasi, etc)
2. Sweet rennet set (Halloumi)
3. Combo of acid and rennet(most continental cheese types)

Usually the issue does not lie with the rennet, but with the milk – and specifically with pasteurisation(not homogenisation).  The issue is with retail milk being over-pasteurised for maximum shelf-life.  This causes the milk protein to be denatured and the rennet enzyme does not “recognise” the protein.  Much like the change we see from raw egg to cooked egg.   Think about this:  calves drink raw milk in nature, so the enzyme is made to work on raw milk.  If you do not believe me, take some UHT long-life milk and put some rennet in it….nothing happened?  Right you are!

Also remember that effective pasteurisation is a combination of temperature and time, so even though you do not exceed the recommended temp, if you take too long to cool it down, then you are also over-pasteurising.

So with rennet coagulation we have 3 main factors:

1. the rennet
2. the milk protein(casein)
3. soluble calcium(calcium chloride addition)

If one milk has a lower protein level than another, then all factors considered, it will set slower and weaker.   If milk is diluted by water, then the calcium and the protein in the milk, will be less and affect the setting.

Antibiotics do not have an influence on setting: https://www.youtube.com/watch?v=8i_20A8nCd8

With new rennet or milk source, I always like to do a little test, where I heat half a cup of the milk in the microwave to 35C and then add a small amount of rennet – if the milk coagulates within half an hour, then it will work with the bigger volume too.   This saves you from putting 20 litres into a pot, going through the motions, only to discover that the milk is not setting.

So where do I look first for problems:

1. over-pasteurisation
2. dilution
3. mastitis milk(this lowers casein and produces other enzymes not helpful in your cheese making, and lifts pH)
4. too high or low temperatures(too high will knock-off the rennet and too low will have you waiting forever)
5. As rennet is a stomach enzyme it works great in acid environment, so high pH will negatively affect it.